Wall Mount Model # WM-1
Owner's Manual

IMPORTANT:
 PLEASE READ ENTIRE INSTALLATION/
 OPERATING INSTRUCTIONS BEFORE 
 INSTALLING OR OPERATING THE POINT 
 AND CUT PAPER TOWEL DISPENSER

Installation Instructions  Dimensions  Electrical Requirements
Loading Instructions  Operating Instructions  Helpful Hints  Warranty

Installation Instructions

1. Attach Model #WM-1 to the wall (or underside of kitchen cabinet) with #6 screws and flat washers that are anchored sufficiently to permanently support the weight of the unit.
   
   There is a hole in each upper corner of the back panel for wall mounting purposes.  In addition, there are 4 holes in the top panel for mounting the unit to the underside of a cabinet.
   
   NOTE:  If mounting the "Wall Mount" unit under kitchen cabinets, try to maintain at least 8" from bottom of unit to countertop to allow paper towel to be dispensed without touching countertop.
   
   To ease under cabinet mounting, make a cardboard template of the top of the unit with the location of the (4) mounting holes marked on the template.  Tape the template to the location where the unit is to be mounted and drill starting holes through the hole marks on the template.
    

2. Connect the adapter

• The DC plug goes into the DC connector (located in the bottom rear center of the unit) and the AC adaptor gets plugged into a 120VAC outlet.

• Note:  The DC power cord could be run behind the unit to conceal it.  Also, a recessed electrical receptacle could be installed to further conceal the DC electrical cord.

• If your power supply fails, it must be replaced with a UL listed direct plug-in power unit marked "Class 2" and rated 24VDC at 500ma to 600ma.

Dimensions:  6 1/2"D     12 1/4"H     16 7/8"W

Loading Instructions

To load a new roll of paper towels:

1. Open the door.

2. Insert the dowel rod through the center of the paper towel roll.

3. Place the dowel into the cradle notches.

4. Tear off the first sheet of the paper towel roll to assure a fresh sheet when loading.

5. Insert the end of the paper towel roll into the slot (as shown at RED arrow in the picture below), until the paper towel comes out of the bottom.  It sometimes helps to move the towel from side to side.

6. Close the front door.

Operating Instructions

1. To UNROLL the amount of paper towel you desire place your hand between the sensors on the right as shown above.

2. To CUT the towel place your hand between the sensors on the left as shown above.
    

3. The paper towel will remain hanging until the user takes it away.

Helpful Hints

To clean the stainless steel, the door needs to be opened.  This disconnects the power which allows cleaning around the sensor areas without activating "unroll" or "cut".

Customers have reported that Endust does a nice job of cleaning the stainless steel.

If the paper towel does not feed out, tear off one (1) sheet and try reloading with a fresh edge.

If the cutting mechanism has not been activated, the door can be opened and the paper towel can be rolled back up if the user decides they dispensed more towel than necessary.

Any size or brand of household-style paper towel, like you get from the supermarket, can be used.

Warranty

3 Year Limited Warranty

Your Point and Cut Warranty covers defects in materials or workmanship of this No-Touch Paper Towel Dispenser and at Point and Cut’s option will repair or replace this product or any component of the product found to be defective at Point and Cut’s expense (less Shipping & Handling charges), for 1 year from the date of original purchase.  After the first year and continuing through the third year from the date of original purchase Point and Cut will replace any parts that prove to be defective under normal conditions without charge, excluding any labor and Shipping and Handling charges incurred in the performance of this warranty.

This warranty is valid for the original purchaser from the date of the initial purchase and is not transferable. 

It is recommended that you keep the original sales receipt and the original packaging materials.

Proof of purchase and a Return Authorization number are required to obtain warranty performance.  (See below for instructions to acquire a Return Authorization number).

Specifically excluded from this warranty are failures caused by connection to electrical service other than standard household current of 120VAC, accident, misuse, neglect, abuse, including tampering, modification or attachments, unsuitable physical or operating environment, maintenance by anyone other than Point and Cut, operation of the product beyond the limit of its duty cycle, spills of food or liquid, external forces such as floods, fires, acts of God or other circumstances beyond Point and Cut’s control.

This Warranty gives you specific legal rights and you may also have other rights, which vary from state to state.

The warranties described shall be in lieu of any other warranties expressed or implied, and all warranties of every nature shall be limited to the periods of time therein stated.

Point and Cut will not be liable for any damages of any kind resulting from the purchase, use or misuse of, the product. Point and Cut assumes no liability greater than the original purchase price.

For assistance with installation or operating the Point and Cut paper towel dispenser, or for instructions on repairs or replacement, please E-mail techsupport@pointandcut.com with your Contact information, type of problem you are having and a good time to reach you and a service technician will contact you.  If a service technician deems a repair is necessary, Point and Cut will assign a Return Authorization number to you.

***UNITS SHIPPED WITHOUT A RETURN AUTHORIZATION NUMBER CANNOT BE ACCEPTED***